Iso Vs Ansi Solidworks -

"The geometry is fine," Silas said, his voice dropping to a whisper, as if explaining a murder mystery. "But the intent is broken. This is a story of two worlds, Elias. The Metric world, and the Imperial world."

To customize:

SOLIDWORKS allows you to mix standards via : iso vs ansi solidworks

defaults to Third Angle Projection . If you are in North America, this is the language your shop floor speaks. "The geometry is fine," Silas said, his voice

"See that?" Silas asked. "That’s an inch dimension converted to metric. 25.4 mm is exactly one inch. If you leave that as a metric dimension for a metric manufacturer, they will cut it to 25.4. But if your clearance is 25.0, you have a problem. This part is a 'Modeling Hybrid.' It thinks it's metric, but its soul is Imperial." The Metric world, and the Imperial world